LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
MLC Maintenance -- C,S Bits and Register
C Bit 201
C Bit 202
C Bit 203
C Bit 204
Description:
Absolute encoder Reset Ready Signal:X Axis
Absolute encoder Reset Ready Signal:Y Axis
Absolute encoder Reset Ready Signal:Z Axis
Absolute encoder Reset Ready Signal:4th Axis
When LADDER finishes absolute encoder zero return, this signal needs to be sent out to notify
NC that.
C Bit 207
C Bit 208
C Bit 209
C Bit 210
Description:
Absolute Encoder Data Ready Signal:X Axis
Absolute Encoder Data Ready Signal:Y Axis
Absolute Encoder Data Ready Signal:Z Axis
Absolute Encoder Data Ready Signal:4th Axis
LADDER will notify NC when driver enters into ABS transmitting mode and driver data are
ready.
C Bit 213
C Bit 214
C Bit 215
C Bit 216
Description:
Absolute Encoder Data Bit 0Transmitting Signal : X Axis
Absolute Encoder Data Bit 0Transmitting Signal : Y Axis
Absolute Encoder Data Bit 0Transmitting Signal : Z Axis
Absolute Encoder Data Bit 0Transmitting Signal : 4th Axis
Assumed absolute encoder data reading is sent by serial transmitting. Also, assumed 2 bits of
Encoder will be transmitted every time. So, when this bit is ON, it indicates that the signal of
transmitting 2 bits data from driver to NC is 1.
LNC Technology Co., Ltd. 97