LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
1076 JOG SPEED OF 2ND SPINDLE
1077 JOG SPEED OF 3RD SPINDLE
1121 JOG SPEED OF 1ST SPINDLE
Range: 0 ~ 99999
Active: Active After RESET
Level: Machinery Builder
Default 200
value:
Unit: RPM
Description
:
When C BIT 072 is ON, spindle will rotate in this parameter’s setting rotational
speed.
1150 SPEED OF 1ST SPINDLE GEAR
Range: 0 ~ 99999
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: RPM
Description this parameter is to determine whether or not to do gear
:
shifting motion according to the spindle S code command.
1. when the spindle is at 1 st gear and assuming that the user command of the
spindle S code command is larger than (not including equal to) this
parameter setting value, the system will inform PLC to do the gear shifting
motion (shifting to which gear depends on the spindle commanding
rotational speed);
2. when the spindle is NOT at 1 st gear and assuming that the user command
of the spindle S code command is smaller than (including equal to ) this
parameter setting value, the system will inform PLC to shift the spindle to
the 1 st gear;
3. if no spindle gear shifting need, recommend to use the 4 th gear (C BIT
097 – 099 are OFF) and set this parameter to 0.
Need to pay attention to the following: NC only follow S code command from the
user command of to determine the desired gear and then to inform PCL to
execute gear shifting motion. If due to the spindle rotational speed OVERRIDE,
which cause the actual rotational speed is over that gear range, then NC will
NOT execute the above motion.
1151 SPEED OF 2ND SPINDLE GEAR
Range: 0 ~ 99999
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: RPM
Description this parameter is to determine whether or not to execute the
:
gear shifting motion according to the spindle S code command.
1. when the spindle is at 2 nd gear and assuming that the spindle S code
LNC Technology Co., Ltd. 197