LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
method is force setting.
64 HOME DOG 0)NC 1)NO
Range: 0 ~ 1
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description:this parameter works only when the home DOG sensor signal
is connected to LOCAL INPUTS (Transit Board HS1 〜 HS4 connect
points). (Parameter 0175 setting value is 0). If the home dog sensor signal
is connected REMOTE INPUTS, then PLC ladder diagram program needs
to change each axis home DOG signal state to C BIT 0031 〜 0035 in
order to inform NC.
76 ENABLE ABS SET AFTER HOMING
Range: 0 ~ 1
Active: Active After RESET
Level: Machinery Builder
Default 1
value:
Unit: Nul
Description:please refer to 1014 ~ 1017 for absolute coordinate setting
value. After each servo axis returns home, display value of absolute
coordinate is determined by following three points:
a. setting value of parameters 1014 ~ 1017;
b. 00 coordinated system, setting value of G54 ~ G59 coordinate system;
c. setting value in G52 area coordinate system.
⎛00
coordinate value
⎞
⎜
⎟
Para#1014 ~ 1017 value − ⎜+
G54 ~ G59 coordinate value ⎟
⎜
⎟
⎝+
G52 regional coordinate value ⎠
In addition,
a. setting value of parameters 1014 ~ 1017: use this parameter to decide
whether or not they are effective;
b. 00 coordinate system, G54 ~ G59 coordinate system setting values:
effective permanently;
c. setting value in G52 area coordinate system: use parameter 0133 to decide
whether or not it is effective.
LNC Technology Co., Ltd. 215