LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
1070 1ST SPD RIGTAP ACC. FILTER
Range: 0 ~ 20
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description the bigger the value, the less vibration will occur and the
:
smaller of the following error. But, it is NOT absolute, which means there is
an optimal value under certain filter intensity. When enter 0, it means there
is no filting effect. When enter the maximum value (i.e., 20), it means there
is a completely filting effect, which means the signal is filited completely.
Please adjust this parameter setting value during the rigid tapping machine
adjustment.
1071 1ST SPD RIGTAP OUTPUT INVERSE
Range: 0 ~ 1
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description When the spindle +ive rotating direction under rigid tapping is
:
not the same as that under not rigid tapping mode, please set this parameter to
1. Please adjust this parameter setting value during rigid tapping machine
adjustment.
194 LNC Technology Co., Ltd.