LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
899 USE CE RULE 0)NO 1)YES
Range: 0 ~ 1
Active: Active After RESET
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description
:
0:CE regulations are not applied.
1:CE regulations are applied.
1006 1ST X+ SOFT LIMIT
1008 1ST Y+ SOFT LIMIT
1010 1ST Z+ SOFT LIMIT
1012 1ST 4+ SOFT LIMIT
Range: -99999999 ~ 99999999
Active: Active After RESET
Level: Machinery Builder
Default 99999999
value:
Unit: um
Description
:
This parameter is to set the limitation value of the +ive X-axis software travel
limit. It works only after X axis is completed zero return procedure, or using the
rebooting default value 99999.999 um. If this parameter setting value is smaller
than parameter # 1007 (-ive X-axis software travel limit), it will enable the alarm
system (MOT 4005, 1 st software traveling limit setting error). The +ive X axis 1 st
and 2 nd software
traveling limit is able to execute exchanging through C BIT 140. Please refer to
the description of C BIT. Under the condition that the +ive X axis 1 st software
traveling limit is enabled, when X-axis will excess the restricted range, it will
enable the alarm system (MOT 9001 X-axis over the +ive software travel limit)
or (MOT 4058 over the software travel limit). Please refer to the description of
this warning message.
1007 1ST X- SOFT LIMIT
1009 1ST Y- SOFT LIMIT
1011 1ST Z- SOFT LIMIT
1013 1ST 4- SOFT LIMIT
Range: -99999999 ~ 99999999
Active: Active After RESET
Level: Machinery Builder
Default -99999999
value:
Unit: um
Description
:
This parameter is to set the limitation value of the -ive X axis software travel
limit. It works only after X axis is completed zero return procedure, or using the
LNC Technology Co., Ltd. 251