LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
SYSTEM ALARM and WARNING
INT 3126:BLOCK NOT FOUND
(1)The designated BLOCK is not found.
(2)Check whether or not the designated BLOCK is exist in part program.
(3)Press RESET to clear wrong message error.
INT 3127:ILLEGAL LABEL
INT 3128:FEEDRATE OUT OF RANGE, CHECK G94/G95
(1)Check G94 and G95 are used correctly.
(2)Check whether or not the FEEDRAT F value is too big.
(3)Press RESET to clear the error and adjust G94, G95 and F value.
INT 3130:COORDINATE ERROR
INT 3131:UNKNOWN PLANE
INT 3132:ILLEGAL RADIUS
(1)Using G02, G03 arch cutting command, the final coordinate is NOT on the arch
(2)Check the position of center point, direction and final point’s coordinate value
(3)Press RESET to clear error.
INT 3140:SEND TABLE ERROR
INT 3141:NO FREE VARIABLES
INT 3150:INSUFFICIENT DATA
(1)Not enough executing G code data.(Lack of G10’s P,R,Z)
(2)Supply the needed data.
(3)Press RESET to clear wrong warning message.
INT 3151:IP MAINTAIN ERROR
INT 3152:CC R RETURN
(1)Executing G27,G28,G29,G30 in the CANNED CYCLE.
(2)Cancel the above G codes in CANNED CYCLE before executing.
(3)Press RESET to clear wrong warning message.
LNC Technology Co., Ltd. 265