LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
1035 2ND X- SOFT LIMIT
1037 2ND Y- SOFT LIMIT
1039 2ND Z- SOFT LIMIT
1041 2ND 4- SOFT LIMIT
Range: -99999999 ~ 99999999
Active: Active After RESET
Level: Machinery Builder
Default -99999999
value:
Unit: um
Description
:
this parameter is to set the limitation value of the -ive X axis software travel limit.
It works only after X axis is completed zero return procedure, or using the
rebooting default value 99999.999 um. If this parameter setting value is larger
than parameter # 1034 (+ive X axis
software travel limit), it will enable the alarm system (MOT 4023, 2 nd software
traveling limit setting error). The -ive X axis 1 st and 2 nd software traveling limit is
able to execute exchanging through C BIT 141. Please refer to the description
of C BIT. Under the condition that the -ive X axis 1 st software traveling limit is
enabled, when X axis will excess the restricted range, it will enable the alarm
system (MOT 9002 X axis over the –ive software travel limit) or (MOT 4058 over
the software travel limit). Please refer to the description of this warning
message.
1091 PROTAG
Range: -360000 ~ 360000
Active: Active After RESET
Level: User
Default 0
value:
Unit: um
Description this parameter is to set the default angle for G68 coordinate rotating command.
:
1092 PSCRT
Range: 1 ~ 99999999
Active: Active After RESET
Level: User
Default 1
value:
Unit: Nul
Description when the setting value of parameter# 0143 is 1 (X, Y and Z axes zoom in/out
:
scale is determined by I, J and K of G51 zoom in/out scale command), this
parameter is to set the default zoom in/out scale of X-axis.
LNC Technology Co., Ltd. 253