LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
14 G01 ACC/DEC TIME
Range: 3 ~ 1500
Active: Active After Reboot
Level: Machinery Builder
Default 100
value:
Unit: ms
Description This parameter is to set the acceleration/deceleration time of G00 on ALL
:
SERVO AXIS. The smaller this parameter is, the faster the servo axis reach the
specified speed; vibration, however, would be more indispensable. In 486IPC
version (the IPO is 10ms), the max. value is 2000; in 586IPC version (the IPO is
3ms), the max. value is 1500.
If the set value exceeds the above limit, the 【MOT 4030 set error in X-axis G00
acceleration/deceleration (parameter #0014) 】 warning message will be
stimulated.
24 CHANNEL NO FOR X AXIS
25 CHANNEL NO FOR Y AXIS
26 CHANNEL NO FOR Z AXIS
27 CHANNEL NO FOR 4 AXIS
Range: 0 ~ 6
Active: Active After Reboot
Level: Machinery Builder
Default 0
value:
Unit: Nul
Description
:
if X(Y、Z、4 th ) axis is wired to the Nth-axis port e Transit board, this parameter is
set to N. If no motor is connected, then this parameter is set to 0.
LNC Technology Co., Ltd. 155