LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
1075 1ST SPD SERVOLAG LIMIT
Range: 0 ~ 100000
Active: Active After RESET
Level: Machinery Builder
Default 4096
value:
Unit: Pulse
Description when rigid tapping machine adjustment is complete, please set the value or the
:
allowable following error that is 5-10 times larger of the display value from data
system #26 at DGNOS page. If this setting value is too small, it is possible to
cause the system alarm (MOT 055 rigid tapping spindle servo error is over the
allowable limit) to occur during rigid tapping.
1096 MAX SPEED OF 1ST SPINDLE
Range: 0 ~ 99999
Active: Active After RESET
Level: Machinery Builder
Default 6000
value:
Unit: RPM
Description this parameter is used to set the max rotational speed ofspindle. When spindle
:
command rotational speed, which is set by user, islarger than this Parameter
setting value, the system will restrict the spindlerotational speed according to
this parameter setting value.
LNC Technology Co., Ltd. 195