LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
SYSTEM ALARM and WARNING
6.4 MOT MOTION RELATED ALARM
MOT 4001:X-AXIS ERROR COUNTER OVERFLOW
(1)Motion board X- Axis ERROR COUNTER overflow(16-BIT).
(2)Check or not the commanding speed is too fast.
(3)Check whether or not servo motor is working normally.
(4)Check whether or not the machine is running normally.
(5)Check whether or not the board is normal.
MOT 4002:Y-AXIS ERROR COUNTER OVERFLOW
(1)Motion board Y-AXIS ERROR COUNTER overflow(16-BIT)
(2)Check or not the commanding speed is too fast.
(3)Check whether or not servo motor is working normally.
(4)Check whether or not the machine is running normally.
(5)Check whether or not the board is normal.
MOT 4003:Z-AXIS ERROR COUNTER OVERFLOW
(1)Motion board Z-AXIS ERROR COUNTER overflow(16-BIT)
(2)Check or not the commanding speed is too fast.
(3)Check whether or not servo motor is working normally.
(4)Check whether or not the machine is running normally.
(5)Check whether or not the board is normal.
MOT 4004:4TH-AXIS ERROR COUNTER OVERFLOW
(1)Motion board 4th-AXIS ERROR COUNTER overflow(16-BIT)
(2)Check or not the commanding speed is too fast.
(3)Check whether or not servo motor is working normally.
(4)Check whether or not the machine is running normally.
(5)Check whether or not the board is normal.
MOT 4005:SET FIRST SOFT LIMIT ERROR
(1)Error setting of 1st soft limit parameter (i.e., +ive soft limit is smaller than –ive soft
limit) Please check parameter numbers 1006~1013.
(2)Clicking RESET to set new parameter.
(3)After changing the parameter, please reboot.
268 LNC Technology Co., Ltd.