LNC-M600 Leading Numerical Controller Maintenance Manual

LNC-M600
Parameter
1042 G31 WORK FEEDRATE
Range: 1 ~ 99999999
Active: Active After RESET
Level: Machinery Builder
Default 2000
value:
Unit: um/min
Description If the feedrate is specified in G31 block, the command value will be the feedrate
:
of the block; if no feedrate is specified in G31, then the feedrate is the set value
of this parameter.
1061 Thread Cutting Max. Feedrate
Range: 1 ~ 99999999
Active: Active After RESET
Level: Machinery Builder
Default 10000000
value:
Unit: um
Description During Lathe tapping, cutting axis feedrate is decided by Spindle rotational
:
speed and thread pitch. When the combination value cause the cutting axis
feedrate is over this parameter setting value, System Alarm【MOT 4061: Lathe
Tapping Speed Over Setting Value】 will occur.
168 LNC Technology Co., Ltd.