Specifications - City of Montpelier, Vermont

Montpelier District HeatingCity of Montpelier, VTIssue Date:September 28, 2012Title:APPENDIX A – Welding and Testing RequirementsPage #:19 of 224.2 The following relevant indications are unacceptable:4.2.1 Any cracks or linear indications;4.2.2 Rounded indications with dimensions greater than 3/16" (5.0 mm);4.2.3 4.2.3 Four or more rounded indications in a line, separated by 1/16"(2.0 mm) or less, edge to edge;4.2.4 Ten or more rounded indications in any six square inch (3870 MM²) ofsurface with the major dimension of this area not to exceed six inches(150 MM) with the area taken in the most unfavorably location relative tothe indications being evaluated.5.0 RE8EXAMINATION OF REPAIRSRepairs of all defects disclosed by liquid penetration examination shall be re-examined inaccordance with this Specification.6.0 RECORDS AND SUBMITTALS6.1 Three copies of the following documents shall be submitted to theENGINEER for review and release:6.1.1 Paragraph 1.1 Liquid penetration examination procedure6.1.2 Liquid Penetration Examination Report6.1.3 Personnel Certifications6.2 Liquid penetration examination results shall be reported on a written report formcontaining at least the following data:6.2.1 Client Name (Owner)6.2.2 Identification of the Piping System (Project Number)6.2.3 Weld Joint Identification.6.2.4 Date of Examination.6.2.5 Signature of Examiner.6.2.6 Examination Procedure Number.6.2.7 Material Identification.6.2.8 Type of Penetration Method used.6.2.9 Results of examination and defect locations before repair.6.3 The CONTRACTOR shall obtain verification from the OWNER’S Representativethat all liquid penetrant examinations are completed in accordance with thespecifications and is acceptable.APPENDIX APage A19