Specifications - City of Montpelier, Vermont

Materials:• Purchase, shipment, and construction of interior service entry valves and shunt assembly• Furnish and Install communication conduits and pull rope• Furnish and Install warning tape• Remove existing concrete sidewalk• Remove existing bituminous concrete paving• Remove (and reset) existing granite curb• Remove existing sod and topsoil• Purchase and shipment of piping• Purchase and shipment of pipe fittings (including the tee in the main associated with the service lateral)• Purchase and shipment of valves• Restoration of existing surface conditions, complying with the project documentsAll materials necessary to install the service lateral in its entirety.Method of Measurement:The quantity of InFGround Hot Water Piping Pipe will be paid at the Lump Sum bid for the Customer ServiceLateral or Spur. See Division II, Specification Section 033615 Hot Water Pipe Distribution System.Basis of Payment:The accepted quantity of Customer Service will be paid for at the Lump Sum Contract price for construction ofthe service to the designated building. Payment shall include all labor, equipment, and materials necessary forthe installation of the identified size of hot water pipe, including, but not limited to: excavation, bedding, andbackfill; compaction; expansion board installation; pipe fitFup and placement; welding; installation of bends,tees, isolation valves, air release valves, and other fittings as shown in the Plans; required testing of welds (dyepenetrant, hydrostatic, etc.); pipe cleaning; insulation and sealing of each joint, including but not limited toinsulation installation, sleeve installation, and joint sealing; construction of the alarm wiring system, includingbut not limited to all testing, solder, wire standoffs, crimping tools, and butt connectors; installation of conduitpipe, handholes, and junction boxes inside each building; fiber optic installation; warning tape installation;service entry core drilling and sealing; the full installation of service entry, including but not limited to valves,shunt assemblies, and insulation, per Detail XX in the Plans; and all asFbuilt requirements as outlined in Section01710 – Project Closeout Requirements. Payment for this Bid Item shall also include all surface restorationrequired to replace disturbed surface features along the pipe excavation, according to the standards establishedby Montpelier Department of Public Works.If the CityFOwned Main piping moves during construction and the service lateral or spur length must increase oraccommodate the change, the additional monies will be calculated based on the lengths and the pay items forsameFdiameter City Owned Main piping.Equipment:As needed.^ Item 150 < Bituminous Pavement Overlay, Fairpoint Parking LotA. Description:This item consists of furnishing, laying and compacting a single 1 ½” thick lift of VTrans wearing course TypeIII mix wich shall be placed as directed by the engineer. The contractor shall accomplish any necessaryleveling of the base course, patching or repairing, with Type II binder mix unless otherwise indicated on theplans or as directed by the Enineer. Pror to placing any material on the original base course, the survaceshall be cleaned and a tack coat of bitumionous material applied for bonding purposes.1. All valve boxes, service boxes, manhole covers, catchbasin grates and rims shall be adjusted to meetfinal grade by the Contractor. Care shall be taken to insure these facilities remain free frompavement or debris during construction.2. All pavement markings shall be reapplied to the final surface as directe by the Engineer.3. Installation of bituminous concrete pavement shall be in accordance with Specification SectionMontpelier District Heat SystemPage 72