Specifications - City of Montpelier, Vermont

Montpelier District HeatingCity of Montpelier, VTIssue Date:September 28, 2012Title:15900 – Direct Digital Control SystemPage #:39 of 409. Pointtopoint checkout.10. Glossary of fully expanded point acronyms.C. Documentation1. Detailed illustrations and complete calibration procedures.2. Complete troubleshooting procedures and guidelines for all systems.3. This material would appear in hardware and software manuals previouslydescribed.3.8 TRAINING OF OWNER PERSONNELA. Training Plan: The Contractor shall provide designated Owner personnel training onthe control system in this facility. The intent is to clearly and completely instruct theOwner on all the capabilities of the control system. The trainers are expected to be fullyprepared and experienced in training.B. Training I. Control System. The first training shall consist of 8 hours of actual training.This training may be held onsite. Upon completion, each student, using appropriatedocumentation, should be able to perform elementary operations and describe generalhardware architecture and functionality of the system.C. Training II. Building Systems. The second session shall be held onsite for a period of12 hours of actual handson training after the completion of system startup. Thetraining shall be broken into 34 hour sessions held over a period of approximately 3weeks (one session per week). When appropriate the session shall include instructionon:1. Specific hardware configuration of installed systems in this building and specificinstruction for operating the installed system, including HVAC systems, lightingcontrols and any interface with security and communication systems.2. Security levels, alarms, system startup, shutdown, power outage and restartroutines, changing setpoints and alarms and other typical changed parameters,overrides, freeze protection, manual operation of equipment, optional controlstrategies that can be considered, energy savings strategies and set points that ifchanged will adversely affect energy consumption, energy accounting,procedures for obtaining vendor assistance, etc.3. All trending and monitoring features (values, change of state, totalization, etc.),including setting up, executing, downloading, viewing both tabular andgraphically and printing trends. Trainees will actually setup trends in thepresence of the trainer.4. Every screen shall be completely discussed, allowing time for questions.5. Use of keypad or plugin laptop computer at the zone level.6. Use of remote access to the system via phone lines or networks.7. Setting up and changing an air terminal unit controller.8. HVAC system overview.9. Operation of Control System.10. Function of each Component.DIRECT DIGITAL CONTROL SYSTEMS1597239