Specifications - City of Montpelier, Vermont

Title:Montpelier District Heating16100 – Site ElectricalCity of Montpelier, VTIssue Date:September 28, 2012Page #:6 of 8B. Acceptable Manufacturers and Products:1. "Warnoline" tape by Safety Sign Company, Cleveland, Ohio,2162387721.2. "Shieldtec" tape by Thor Enterprises, Inc., P.O. Box 450, Sun Prairie, WI53590, 6098377197 or 800USATHOR.3. Or equal as approved by the OWNER.PART 3– EXECUTION3.1 EXAMINATIONA. Examine the areas and conditions under which electrical construction andassociated work is to be performed. Do not proceed with the Work untilunsatisfactory conditions have been corrected.3.2 PREPARATIONA. Coordinate all electrical work operations to protect existing and/or newconcurrent construction.3.3 ALIGNMENT AND GRADEA. In general, communication conduits are placed above the hot water pipe lines, asindicated on the Plans. Where placed over separate routes, maintain alignmentand grade as described in Section 33615 – Hot Water Pipe Distribution System,Part 3.2. Any deviations from the location of the conduit above the hot waterlines shall be noted and included in the AsBuilt Documentation in accordancewith Section 01710 – Project Closeout Requirements, Part 1.5.3.4 CONDUIT LAYING AND JOINTINGA. Conduit Laying:1. Remove all foreign matter or dirt from inside of conduit before it is loweredinto its position in trench.2. Keep conduit interior and joints clean during and after laying.3. Replace any defective or damaged conduit, or conduit with grade or alignmentdisturbed after laying.4. At suspension of work, place suitable closures to prevent earth or water fromentering conduit.5. Lay no conduit in water.SITE ELECTRICAL161006