Specifications - City of Montpelier, Vermont

Title:Montpelier District Heating16140 – Wiring DevicesCity of Montpelier, VTIssue Date:September 28, 2012Page #:4 of 62. Ground fault interrupting type receptacles shall be Cat. No. 8899W.2.3 WIRING DEVICE ACCESSORIESA. Wall plates: Single and combination, of types, sizes, and with ganging and cutoutsas indicated. Provide plates which mate and match with wiring devices to whichattached. Provide metal screws for securing plates to devices with screw headscolored to match finish of plates. Provide wall plate color to match wiringdevices except as otherwise indicated. Provide wall plates with engraved legendwhere indicated. Conform to requirements of Section "Electrical Identification."Provide plates possessing the following additional construction features:B. Interior finished locations:1. Material and Finish: 0.04 inch thick, type 302 satin finished stainlesssteel.2. Material and Finish: 0.05 inch thick aluminum, anodized.3. Material and Finish: Plastic, smooth.C. Interior unfinished locations:1. Material and Finish: Steel plate, galvanized.D. Interior and exterior locations:1. Damp locations: In areas classified as damp location per the NEC thedevice cover shall be Diecast metal with selfclosing lid, Cat. No. 4976.2. Wet locations: In areas classified as wet location per the NEC the devicecover shall be thermoplastic with selfclosing lid, which for receptacleswould allow a cord to be plugged in and the lid closed, Cat. No. 5977.PART 3 EXECUTION3.1 INSTALLATION OF WIRING DEVICES AND ACCESSORIESA. Install wiring devices and accessories as indicated, in accordance withmanufacturer's written instructions, applicable requirements of NEC and inWIRING DEVICES161404