Specifications - City of Montpelier, Vermont

Montpelier District HeatingCity of Montpelier, VTIssue Date:September 28, 2012Title:15900 – Direct Digital Control SystemPage #:38 of 408. Tests that fail to demonstrate proper system operation shall be repeated afterContractor makes necessary repairs or revisions to hardware or software tosuccessfully complete each test.B. Acceptance.1. After tests described in this specification are performed to the satisfaction ofOWNER’s Representative, OWNER’s Representative will accept controlsystem as meeting completion requirements. OWNER’s Representative mayexempt tests from completion requirements that cannot be performed due tocircumstances beyond Contractor's control. OWNER’s Representative willprovide written statement of each exempted test. Exempted tests shall beperformed as part of warranty.2. System shall not be accepted until completed demonstration forms andchecklists are submitted and approved as required.3.7 O&M DOCUMENTATION REQUIREMENTSA. The following O&M manual requirements do not replace O&M manual documentationrequirements elsewhere in these specifications.1. Contractor shall compile and prepare documentation for all equipment andsystems covered under this specification and deliver this to the OWNER’sRepresentative according to governing Division 1 section.B. Provide two paper copies and one electronic copy submitted according to Section 01340of material required in this Section, to be bound similarly but separately, describingoperation, maintenance and servicing requirements of the HVAC&R control system andassociated equipment. Provide the following information in separate sections each withtab index:1. Material list2. Technical literature for all equipment including catalog sheets, calibration,adjustments and operation instructions, and installation instructions, (theoperator's instruction portion may be separately bound).3. Hardware and software manuals, including supplied media, that is supplied bythe original product developer, for all required features and the controlsapplication programs themselves, on computers and controllers provided byvendor.4. List of spare parts (with model numbers) recommended for purchase by theOwner.5. System description and complete sequence of operation.6. Reduced size (11 inch by 17 inch) copies of record drawings.7. Input/Output (I/O) summary forms for the system listing all connected analogand Digital input and output functions and the number types of points. Indicatespare input/output capacity.8. Control programs specific to this system.DIRECT DIGITAL CONTROL SYSTEMS1597238