Specifications - City of Montpelier, Vermont

Title:Montpelier District HeatingCity of Montpelier, VT15190 – Mechanical IdentificationIssue Date:September 28, 2012Page #:3 of 81. Stencil Paint: Standard exterior type stenciling enamel; black, except asotherwise indicated; either brushing grade or pressurized spraycan formand grade.2. Identification Paint: Standard identification enamel of colors indicated or,if not otherwise indicated for piping systems, comply with ANSI A13.1for colors.2.2 PLASTIC PIPE MARKERSA. Snapon or strapon type vinyl markers with integral flow arrows and factoryapplied graphics.B. Insulation: Furnish ½" thick molded fiberglass insulation with jacket for eachplastic pipe marker to be installed on uninsulated pipes subjected to fluidtemperatures of 180° F or greater. Cut length to extend 2" beyond each end ofplastic pipe marker.C. Adjust size of marker and letters to accommodate the outside diameter, includinginsulation, of the pipe identified. Follow the guidelines published in ANSI A13.1for marker/lettering size and color.D. Lettering: Include in the submittal the manufacturer's standard preprintednomenclature which best describes piping system in each instance, for review bythe Architect/Engineer.E. Arrows: Print each pipe marker with arrows indicating direction of flow, eitherintegrally with piping system service lettering (to accommodate both directions),or as a separate unit of plastic.F. Manufacturer: Subject to compliance with requirements, provide mechanicalidentification materials of one of the following:1. Brady (W.H.) Co.; Signmark Div. – Brady Snapon & Strapon Vinyl PipeMarkers2. Brimar Industries, Inc. – System #1 Pipemarkers3. Seton Name Plate Corp. Setmark2.3 PLASTIC DUCT MARKERSMECHANICAL IDENTIFICATION151903