2 - Fagor Automation

i
X6 connector
This connector of the compact drive identified as X6 may be:
A SERCOS interface connector.
A CAN interface connector.
An RS-232/422 serial line connector (only on CMC drives).
X6. SERCOS
This connector consists of a SERCOS signal receiver and emitter (Honeywell
IN, OUT) and may be used to connect the modules of the DDS system
with the CNC that governs them. The connection is made through
fiber optic lines and it has a ring structure.
It will always come with a node selecting rotary switch (Node Select) that
lets identify each drive within the system.
0 8
X6. CAN
NODE
OUT
IN
STATUS
DISPLAY
F. H3/130
Honeywell emitter-receiver for SERCOS transmission.
INFORMATION. Note that on compact drives ACD, SCD and CMC, this
connector will always come with connector X5.
5-pin female connector where only three pins are connected CANL(2),
SHIELD (3) and CANH (4) and may be used to connect the module of the
DDS system with the CNC or another master element (ESA panel) that
governs them.
The connection is made with a CAN cable and it has a field bus network
type structure. It will always come with a node selecting rotary switch
(NODE SELECT) that lets identify each drive within the system.
F. H3/131
CAN interface connector.
Line terminating resistor ON (1) / OFF (0)
selecting switch.
Drive modules
DRIVE MODULES
Compact drives 3.
DDS
HARDWARE
Ref.1307
177