2 - Fagor Automation

Cables
7.
CABLES
Mains connection cable. Power supply - mains connection
266
DDS
HARDWARE
Ref.1307
248
7.1 Mains connection cable. Power supply - mains connection
Refer to table T. H5/14 of chapter 5 to determine the cable needed to connect
the power supply to mains. Note that compact drives have it integrated
into them.
The table T. H7/2 shows the mains connection cable supplied by FAGOR
and their sales reference is MPC-x.
T. H7/2 Range of mains connection cables.
MPC-4x1.5 MPC-4x4 MPC-4x10 MPC-4x25 MPC-4x50
MPC-4x2.5 MPC-4x6 MPC-4x16 MPC-4x35 MPC-4x70
The 4 wires of the mains cable must be connected to the power supply or
to the compact drive (integrated power supply) as shown in figure F. H7/1.
From Mains
N
R S T
L1
L2 L3
RST phases may
be connected in
any sequence.
F. H7/1
MPC cable connection from the power supply or compact drive to mains.
Power leads. Mechanical characteristics
The following table shows the mechanical characteristics of the terminals
(L1, L2, L3, PE) at the power supplies and at the compact drives.
T. H7/3 Mechanical characteristics of the power connectors for the power
supplies and compact drives.
Module Gap
(mm)
MPC- 4x...( mm2 Ready Made Cable
)
Max.
tightenin
torque
(N·m)
Max. hole
section
(mm²)
Min. cable
section
(mm²)
PS-65A 18.8 7 70 50
PS-25B4 10.1 1.5 16 10
XPS-25 12.1 2 16 10
XPS-65 18.8 7 70 50
RPS-80 25.0 20 95 70
RPS-75 25.0 20 95 70
RPS-45 18.8 7 70 35
RPS-20 10.6 1.5 16 10
ACD/SCD/CMC 1.08/1.15 7.62 0.5 4 2.5
ACD/SCD/CMC 1.25 7.62 0.7 6 4
ACD/SCD/CMC 2.35/2.50 10.16 1.2 6 6
SCD 2.75 10.16 1.5 16 10