2 - Fagor Automation

Installation
8.
INSTALLATION
Connection of the control and communications signals
312
DDS
HARDWARE
Ref.1307
308
RS-422 serial line connection
NOTE. This communication interface may be set only between drive modules
MMC or CMC and an ESA video terminal as a master element.
The various drive modules and the ESA panel are connected through the
RS-232/422 serial port (connector X6) of the drive and the serial port of the
video terminal (connector MSP).
The RS-232/422 serial port is implemented only on FAGOR drives in
motion control applications (see their front panel).
The connection is made through the RS-232/422 cable.
See chapter 7. CABLES of this manual.
It is a tree type connection where the 16-position rotary switch (0-15) of
each drive permits selecting the address of each module integrated in it.
NOTE. The system communication through RS-232/422 is configured using
the WinDDSSetup application for PC. See the “communications” tab
of the menu in chapter 16. WINDDSSETUP of the “ddssoftware”
manual.
Particular
In order to establish communication via RS-232 serial line, each drive of the
system must be differentiated using the 16-position “NODE SELECT”
switch. The direction of the arrow of the switch must coincide with an identifier
other than zero, hence assigning a node number that will identify in the
system.
If the drive is going to be identified in the SERCOS ring with a number higher
than 15 in a tree-like structure that has RS-422 communications line, this
value cannot be selected using the rotary “NODE SELECT” switch because
it only has 15 positions.
Identifying the axes with addresses higher than 15 requires setting QP13.
See this parameter in chapter 13 of the “dds-software” manual.
Example.
How to identify an axis addressed in position 26 in the system when communicating
via RS-422 serial line ?
When the identifier of the axis is higher than 15 (like in this case), QP13
must be set so it meets the ratio:
Defined ID = ID to be selected at the rotary switch + (15 x QP13).
Hence, for defined ID = 26, select C (same as 11) at the drive's rotary
“NODE SELECT” switch and set QP13=1.
In order to establish communication via RS-232 serial line, the direction of
the arrow of the switch of the corresponding module must coincide with the
zero identifier.
NOTE. The module must be reset in order for any change made on the
rotary switch to be effective.
Interconnection
Use the RS-232/422 cable to connect all the drives that will be governed by
the video terminal. See chapter 7. CABLES of this manual.