2 - Fagor Automation

13.6 VECON-3 board
13.7 VECON-4 board
13.8 Boot for VECON-2
13.9 Boot for VECON-3
13.10 Boot for VECON-4
13.11 SERCOS card (16 MBd)
i
This board replaces the VECON-2 board.
Version of the VECON-3 board Software version
VEC 01A and later 06.18 and later
NOTE. It is possible but not recommended to have the same machine
with several units where one controls its motor with a 04.xx version and
hardware with VECON another one that controls its motor with a 05.xx
version and hardware with VECON-2 and a third one that controls its motor
with 06.18 version or later and VECON-3 hardware.
This board replaces the VECON-3 board.
Versión of the VECON-4 board Software version
VEC 01A and later 06.26 and later
08.05 and later
NOTE. It is possible but not recommended to have the same machine
with several units where one controls its motor with a 05.xx version and
hardware with VECON-2 another one that controls its motor with a
06.18 version and hardware VECON-3 and a third one that controls its
motor with 08.05 version and hardware VECON-4 hardware.
The boot of version v.06.02 and later of the WinDDSSetup allow loading
the software versions on VECON-2 boards (version VEC2 02A).
NOTE. The boot of previous WinDDSSetup versions is incompatible with
board versions VEC2 02A.
The boot of version 06.18 and older of the WinDDSSetup allow loading
the software versions on VECON-3 boards (version VEC3 01A).
NOTE. The boot of previous WinDDSSetup versions is incompatible with
board versions VEC3 01A.
The boot of versions 06.26 and 08.05 and older of the WinDDSSetup allow
loading the software versions on VECON-4 boards (versión VEC4
01A).
NOTE. The boot of previous WinDDSSetup versions is incompatible with
board versions VEC4 01A.
This card will not be compatible with software versions older than 06.05.
With software versions 06.05 and later, this new board may be used to exchange
data between the CNC and the drives that make up the SERCOS
ring at 2, 4, 8 and 16 MBd.
NOTE. Therefore, in order to select a baudrate higher than 4 Mbaud, the
drive must have this SERCOS board and software version v.06.05 or newer.
INFORMATION. Drives having this board or older ones may be added to
the SERCOS ring. However, all the drives must set with the same transmission
speed.
Compatibility
COMPATIBILITY
VECON-3 board 13.
DDS
HARDWARE
Ref.1307
381