2 - Fagor Automation

Installation
8.
INSTALLATION
Location
312
DDS
HARDWARE
Ref.1307
268
MANDATORY. When integrating the unit into the electrical cabinet, make
sure to leave a gap of at least 10 cm (3.93 inches) between it and the top,
bottom and front panel of the cabinet or any other obstacle that obstructs
air flow for easier heat evacuation.
For further detail, see next figure:
AIR
F. H8/1
Top and bottom clearance when installing the DDS system for easier heat
evacuation.
Climatic considerations
AIR
MANDATORY. Mount the modular drive of greatest power next to the
power supply module and use the same criteria for the rest of the drive
modules.
The temperature inside the electrical cabinet containing the servo drive
system must not exceed 55 °C (131 °F).
MANDATORY. Never install the DDS system next to a heat source.
The modules generate heat and when trying to decide whether the electrical
cabinet containing the DDS system needs external cooling or not, one
must know the power dissipated by each one of its modules.
See next table to know the power dissipated by each one of them.
T. H8/1 Power dissipated by the modules of the DDS system.
Power supply module Power dissipated at max. load.
PS-65A 275 W
PS-25B4 180 W
XPS-25 180 W
XPS-65 350 W
RPS-80 1 000 W
RPS-75 1 000 W
RPS-45 700 W
RPS-20 500 W