2 - Fagor Automation

7.5 Signal cables for control and communications
i
Encoder simulator from the drive to the CNC
Depending on motor feedback, the drive can generate a set of signals
that simulate those of a differential TTL encoder attached to the rotor of
the motor. The attached tables show this cable supplied by FAGOR to
connect the drive (X3) and the CNC 8055 (X1, X2, X3 or X4) / 8055i (X10,
X11, X12 or X13) / 8065/8070 (LOCAL COUNTER 1/2). The attached tables
show this cable supplied by FAGOR to connect the drive and the
CNC. They are supplied with connectors at both ends and their sales reference
is:
SEC-HD- cable
T. H7/15 Range of SEC-HD- cables. The number indicates their length
in meters including the connectors.
SEC-HD-1 SEC-HD-10 SEC-HD-25
SEC-HD-3 SEC-HD-15 SEC-HD-30
SEC-HD-5 SEC-HD-20 SEC-HD-35
11
15
(HD,
Sub-D,
M15)
Front View
to CNC
1
5
Signal Pin
A 1
A 2
B 3
B 4
Io 5
Io 6
AL 7
AL 8
GND 11
CHASSIS
Ready Made Cable SEC-HD-1/3/5/10/15/20/25/30/35
Length in meters; including connectors
Cable 2x4x0.14+1x2x0.5
Pin
Green
1
Yellow
2
Blue
3
Pink
4
Grey
5
Brown
6
White
7
Purple
8
Black
11
Twisted pair. Overall shield. Metallic shield connected to CHASSIS pin
(at the CNC end and at the Drive end)
F. H7/5
Connection of the cable for the encoder simulation and the CNC.
15
11
(HD,
Sub-D,
F15)
Front View
5
1
to DRIVE -X3-
INFORMATION. The max. length for SEC-HD- cables for best performance
is 50 meters.
Cables
CABLES
Signal cables for control and communications 7.
DDS
HARDWARE
Ref.1307
255