2 - Fagor Automation

Installation
8.
INSTALLATION
Connection between modules
312
DDS
HARDWARE
Ref.1307
280
Joining the chassis between modules
The chassis of the modules must be connected to each other through the
terminal on top of each module. To do this, the third plate and the washers
and nuts supplied with each module.
F. H8/9
Joining the chassis between modules.
TOP VIEW:
PLATE ROTATION
The tightening torque must be between 2.32.8 Nm.
Connecting these terminals by means of metal plates offers mechanical rigidity;
but it does not guarantee proper ground connection of each module.
To replace a drive module in case of a failure or remove it from the DDS
system for inspection, follow these steps to “free” it from the other modules.
A. Loosen the screw and the nut of the affected module.
B. Loosen the nut of the adjacent drive on each side that joins it to the
affected drive.
C. Rotate the plate of the affected drive and that of the one to its left, see
figure F. H8/9.
After these steps, the drive will be totally free from the rest of the drives that
were joined by the plate.
All the cables connecting it to the rest of the modules must also be removed.