2 - Fagor Automation

i
However:
The RPS-80 supplies 80 kW and can return up to 80 kW to mains for an S1
duty cycle. For an S6-40% duty cycle it supplies 104 kW and can return
104 kW to mains.
The RPS-75 supplies 75 kW and can return up to 75 kW to mains for an S1
duty cycle. For an S6-40% duty cycle it supplies 97 kW and can return 97
kW to mains.
The RPS-45 supplies 45 kW and can return up to 45 kW to mains for an S1
duty cycle. For an S6-40% duty cycle it supplies 59 kW and can return 59
kW to mains.
The RPS-20 supplies 20 kW and can return up to 20 kW to mains for an S1
duty cycle. For an S6-40% duty cycle it supplies 26 kW and can return 26
kW to mains.
INFORMATION. They all integrate an auxiliary 24 V DC, 8 A power
supply to feed its own control circuits and those of the modular drives
connected to them. Consequently, they will not require the auxiliary power
supply APS-24 to perform this function unless more than 8 A are required.
NOTE PRIOR TO INSTALLATION
Before installing an RPS power supply when using non-FAGOR motors, remember
that:
MANDATORY.
Any element that will be part of the drive-motor system powered by an RPS
must meet the isolation requirements described in EN 61800-5-1.
• All the components connected to the intermediate circuit must run permanently
on a voltage higher than 625 V in the intermediate circuit.
• If the motor temperature sensor is a KTY type, it must also meet the requirements
described in EN 61800-5-1.
RECOMMENDATION.
Configure the RPS power supply with the minimum bus voltage to satisfactorily
meet the features required by the system.
Power supplies
POWER SUPPLIES
Regenerative regulated power supplies 2.
DDS
HARDWARE
Ref.1307
67