2 - Fagor Automation

Power supplies
2.
POWER SUPPLIES
94
88
Regenerative regulated power supplies
DDS
HARDWARE
Ref.1307
1x
1x
The following table shows the values for gap, tightening torque, sections
of the screws and other data of the plug-in connector for X5.
T. H2/35 Data of the plug-in connector for X5.
Connector data
X6 connector
The screwed-on 7-pin Phoenix connector with screw (5.00 pitch) that the
RPS power supply has on its face plate for controlling the module.
A 1.25 A fuse protects the internal circuits.
RPS-80
RPS-75
RPS-45
RPS-20
Nr of poles 2 2
Gap (mm) 5.00 5.00
Min/max tightening torque (N·m) 0.5/0.6 0.5/0.6
Screw thread M3 M3
Min./max. section (mm²) 0.2/2.5 0.2/2.5
Rated current In (A) 12 12
Wire data
Length to strip (mm) 7 7
X6
3
2
1
(Phoenix,
5.08 mm)
F. H2/49
Connector X6. Control.
NOTE. Remember that the internal circuits of PS-65A non-regenerative
power supplies must be powered by an auxiliary 24 V DC power supply,
“APS-24”; that's why its control connector has three terminals more than
connector X6 of the RPS.
The following table shows the values for gap, tightening torque, sections of
the screws and other data of the plug-in connector for X6.
T. H2/36 Data of the plug-in connector for X6.
Connector data
RPS-80
RPS-75
RPS-45
RPS-20
Nr of poles 7 7
Gap (mm) 5.00 5.00
Min/max tightening torque (N·m) 0.5/0.6 0.5/0.6
Screw thread M3 M3
Min./max. section (mm²) 0.2/2.5 0.2/2.5
Rated current In (A) 12 12
Wire data
RPS-
Length to strip (mm) 7 7
X6
Error Reset
GND
PWM Enable
System Speed Enable
System O.K.
(Relay contact N.A)