2 - Fagor Automation

Drive modules
3.
DRIVE MODULES
Compact drives
188
DDS
HARDWARE
Ref.1307
180
Digital inputs
characteristics
Digital outputs
characteristics
Connectors at slots SL1 and SL2
CARD A1
The A1 card must always be in slot SL1.
X6-DIGITAL I/O, digital inputs and outputs
If offers 4 digital inputs and 4 digital outputs, all of them fully programmable.
The digital inputs are optocoupled and referred to a common point (pin 5).
The digital outputs are contact type and also optocoupled.
Each input and output is associated with a parameter. The user may assign
to these parameters, internal Boolean type variables that may be
used to show the system status via electrical contacts.
See “man_dds_soft.pdf” manual.
These assigned Boolean variables are set with the monitor program for
PC (WinDDSSetup).
Phoenix
3.5 mm
X6-DIGITAL I/Os
1
13
(A1 Board)
1
X7-ANALOG I/Os X6-DIGITAL I/Os
1
F. H3/134
A1 card: X6-DIGITAL I/Os. Digital inputs and outputs.
P1
P2
A1
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
IN 1
IN 2
IN 3
IN 4
Maximum rated voltage 24 V DC (36 V DC)
ON/OFF voltage 18 V DC (5 V DC)
Maximum typical consumption 5 mA (7 mA)
Maximum voltage 250 V
Maximum load current (peak) 150 mA (500 mA)
Maximum internal resistance 24
Galvanic isolation voltage 3750 V (1 min)
REF-IN
OUT 1
OUT 2
OUT 3
OUT 4