Specifications - Lord and Son Construction, Inc.

Documents.
C. Roofing Manufacturer’s Warranty: Upon completion of the work, furnish to the
Owner the manufacturer’s written and signed standard roofing & metal warranty,
including asphalt, fasteners, wood blocking, rigid/tapered insulation, recovery
board, modified bitumen system, all metal flashings, liquid flashings, duct and pipe
supports, metal copings, and related accessories, certifying the performance of
his products and the consistency of the properties of such products affecting their
performance for the following:
1. 20 year complete roofing system material and workmanship no dollar limit
system warranty
a. During roof warranty period, manufacturer’s representative and roofing
contractor agree that as soon as practical after receipt of notice from
Owner, they will inspect and cause immediate emergency repairs to be
made to defects and leaks threatening interior of building.
b. Manufacturer and Roofing Contractor further agree to effect permanent
repairs to defects or leaks within 30 days of Owner’s notice without cost
to Owner.
c. The manufacturer shall review the requirements of the plans,
specifications and project prior to bidding. Any conditions which may
negatively effect the warranty must be identified in writing prior to bidding.
No exception to warranty is acceptable.
d. Refer to Division 7 Section “Flashing and Sheet Metal” for metal flashing
information.
D. Emergency Repairs: Owner reserves prerogative of making immediate
emergency repairs, at their own expense, to conditions threatening building
contents without abrogating their rights under this warranty.
E. Type Repairs: Make permanent restoration using proper laminar reconstruction
with hot bitumen and reconstruct to original condition using materials and methods
originally manufacturer specified or as outlined by manufacturer’s written
requirements.
1.11 LABORATORY TESTING
A. Upon request from the Architect the membrane manufacturers shall supply, at
their expense, the results of mechanical and chemical testing performed on the
asphalt materials supplied.
B. The tests shall be performed to certify compliance with the standards referenced
under this section.
C. Other tests may be performed upon request. Refer to “Final Inspection”
paragraph.
1.12 SITE PROTECTION
MAGH121038
07 52 16-5 MODIFIED BITUMINOUS MEMBRANE ROOFING