Specifications - Lord and Son Construction, Inc.

1. Finish faces, all four edges, edges of cutouts, and mortises. Stains and fillers
may be omitted at edges of cutouts, and mortises.
B. Transparent Finish:
1. Grade: Custom
2. Finish: Manufacturer's standard UV cured polyurethane, equal to WDMA TR-
6 catalyzed polyurethane.
3. Staining: As selected by Contracting Officer from manufacturer's full range.
a. Final color, build, and sheen to be approved by Contracting Officer based
on actual review samples.
4. Factory pre-finished doors to be individually protected with transparent polywrap
at the factory.
PART 3 – EXECUTION
3.1 EXAMINATION
A. Examine doors and installed door frames, with Installer present, before hanging
doors.
1. Verify that installed frames comply with indicated requirements for type, size,
location, and swing characteristics and have been installed with level heads
and plumb jambs. Any deficiencies must be corrected prior to door
installation.
2. Reject doors with defects.
B. Proceed with installation only after unsatisfactory conditions have been corrected.
3.2 INSTALLATION
A. Condition doors to average prevailing humidity in installation area prior to hanging.
Building shall be fully enclosed and permanent climate control system operating.
B. Hardware: Coordinate installation with Division 8 Section “Door Hardware”.
C. Installation Instructions: Install doors to comply with manufacturer's written
instructions and referenced quality standard, and as indicated.
D. Job-Fitted Doors: Align and fit doors in frames with uniform clearances and bevels
as indicated below; do not trim stiles and rails in excess of limits set by
manufacturer. Machine doors for hardware. Seal edges of doors, edges of
cutouts, and mortises after fitting and machining.
11-008 08 14 16-5 FLUSH WOOD DOORS