Specifications - Lord and Son Construction, Inc.

SECTION 01000
GENERAL REQUIREMENTS WITH KEESLER AFB SUPPLEMENT
6.1 DESCRIPTIVE DATA
A. The Contractor shall submit three copies of AF Form 3000, Material Submittal Approval, to the
GOVERNMENT for approval. Included shall be manufacturer's descriptive data for materials, fixtures, and
equipment the Contractor proposes to incorporate in the work. The submittal shall include catalog
numbers, diagrams, drawings, and such additional descriptive data and samples required to properly
evaluate all items. When specifications require materials to conform to Federal, Military, Commercial,
AGTM, etc., specifications and standards, the Contractor shall submit supplier's or manufacturer's
Certification of Conformance in addition to other descriptive data. Catalog numbers and trade names
specified indicate examples of a standard product. Other manufacturers' products may be substituted
contingent upon approval. Approval of all items must be obtained prior to fabrication or purchase.
Payment for work incorporating these materials will not be made if required material submittals have not
been approved. Approval of materials, fixtures, and equipment will be based on manufacturer's published
ratings and conformance with specifications.
B. The Material Descriptive Data Submittal shall include, but shall not be limited to, the information
C. indicated in the appropriate specification section.
D. The Shop Drawing Submittal shall include, but shall not be limited to, the information indicated in the
appropriate specification section.
E. The Samples Submittal shall include, but shall not be limited to, the information indicated in the
appropriate specification section.
6.2 CONTRACTOR DEVIATION
When data is submitted for approval, the Government's approval of such data shall not relieve the Contractor from
responsibility for errors or deviation from contract drawings and specifications. In the case of a deviation, the
Contractor shall inform the GOVERNMENT in writing of the request for deviation with all the specific data related
to the change.
7.0 REFERENCED PUBLICATIONS
Any publication referenced in this specification, but not shown in each part under paragraph entitled
"APPLICABLE PUBLICATIONS", also form a part of these specifications to the extent referenced.
8.0 TEMPORARY CONSTRUCTION FENCING
A. Provide and install six-foot (6’) high chain link fence, including gates as indicated, in accordance with
commercial (not residential) industry standards.
B. Zinc coated steel fabric or wire not less than (9) gauge.
C. Hot-dipped galvanized steel fence supports, framing and fittings of commercial grade sizes and weights.
D. Provide Keesler standard brown vision screen.
9.0 REMOVAL PROCEDURES
No removed items will be reused in this contract unless specifically listed in these specifications and/or on the
drawings. All removed equipment becomes the property of the Contractor unless noted otherwise. The Contractor
will be required to furnish lifting equipment as necessary to remove the equipment, and shall provide all equipment
to transport the removed items off base. All unused material or debris will be removed from Government-controlled
property. Use of Government-contracted dumpsters is prohibited. Unused materials, debris and rubbish shall be
disposed of off base in a permitted landfill. The Contractor shall comply with Mississippi Department of
Environmental Management Regulations.
10 EXCAVATION: [see specifications]
Section 01000
Page 5 of 8