Specifications - Lord and Son Construction, Inc.

1.2 SUBMITTALS
bronze and similar finished materials will not require finish painting,
unless otherwise indicated.
5. Operating Parts and Labels:
a. Moving parts of operating units, mechanical and electrical parts, such as
valve and damper operators, linkages, sinkages, sensing devices, motor
and fan shafts will not require finish painting, unless otherwise indicated.
Do not paint over any code-required labels, such as Underwriters'
Laboratories and Factory Mutual, or any equipment identification,
performance rating, name or nomenclature plates.
6. Do not paint concrete or floors, unless specifically indicated.
7. Gypsum wallboard joint preparation is included in Gypsum Wallboard Section.
A. Product Data:
1. Provide manufacturer's printed product data on all coatings specified,
including preparation and application instructions.
B. Selection Samples:
1. Provide two sets of samples not less than one by two inches in size illustrating
range of colors and textures available for each finishing product specified.
C. Verification Samples:
1. Provide two samples of not less than six inches square illustrating selected
color and texture for each finishing product specified.
1.3 QUALITY ASSURANCE
A. Job Sample:
1. Prior to start of painting, paint full size field sample of each individual color
scheduled on each respective substrate. Paint sample at site, where directed,
of workmanship to be expected in the completed work. Obtain Contracting
Officer’s acceptance of the sample before start of work. If sample is
accepted, the sample may become part of the finished project.
1.4 DELIVERY, STORAGE, AND HANDLING
A. Deliver materials to job site in original, new and unopened packages and
containers bearing manufacturer's name and label and following minimum
information:
1. Name or title of materials
2. Manufacturer's name
MAHG121038 09 90 0 - 2 PAINTING AND COATING