Specifications - Lord and Son Construction, Inc.

. The hardware shall perform the control sequences as specified and shown
to provide control of the equipment as specified and shown.
c. Control sequence logic shall reside in DDC hardware in the building.
The building control network shall not be dependent upon connection to
a Utility Monitoring and Control System (UMCS) for performance of
control sequences in this specification. The hardware shall, to the
greatest extent practical, perform the sequences without reliance on
the building network.
d. The hardware shall be installed such that individual control equipment
can be replaced by similar control equipment from other equipment
manufacturers with no loss of system functionality.
e. All necessary documentation, configuration information, configuration
tools, programs, drivers, and other software shall be licensed to and
otherwise remain with the Government such that the Government or their
agents are able to perform repair, replacement, upgrades, and
expansions of the system without subsequent or future dependence on the
Contractor.
f. The Contractor shall provide sufficient documentation and data,
including rights to documentation and data, such that the Government or
their agents can execute work to perform repair, replacement, upgrades,
and expansions of the system without subsequent or future dependence on
the Contractor.
g. Hardware shall be installed and configured such that the Government or
their agents are able to perform repair, replacement, and upgrades of
individual hardware without further interaction with the Contractor.
h. Control hardware shall be installed and configured to provide all input
and output Standard Network Variables (SNVTs) as shown and as needed to
meet the requirements of this specification.
i. All DDC devices installed under this specification shall communicate
via Bacnet MS/TP. The control system shall be installed such that a
SNVT output from any node on the network can be bound to any other node
in the domain.
1.4.2 Verification of Dimensions
After becoming familiar with all details of the work, the Contractor shall
verify all dimensions in the field, and shall advise the Contracting Officer
of any discrepancy before performing any work.
1.4.3 Drawings
The Government will not indicate all offsets, fittings, and accessories that
may be required on the drawings. The Contractor shall carefully investigate
the mechanical, electrical, and finish conditions that could affect the work
to be performed, shall arrange such work accordingly, and shall provide all
work necessary to meet such conditions.
1.5 PROJECT SEQUENCING
Section 23 09 23 Page 7