Specifications - Lord and Son Construction, Inc.

3.11 CLEANING
E. If core cuts verify the presence of damp or wet materials, the Contractor shall be
required to replace the damaged areas at his own expense.
F. Repair or replace deteriorated or defective work found at time above inspection as
required to a produce an installation which is free of damage and deterioration at
time of Substantial Completion and according to warranty requirements.
G. Notify the Architect upon completion of corrections.
H. Following the final inspection, provide written notice of acceptance of the
installation from the roofing system manufacturer.
I. Immediately correct roof leakage during construction. If the Contractor does not
respond within twenty four (24) hours, the Owner will exercise rights to correct the
Work under the terms of the Conditions of the Contract.
A. Clean-up and remove daily from the site all wrappings, empty containers, paper,
loose particles and other debris resulting from these operations.
B. Remove asphalt markings from finished surfaces.
C. Repair or replace defaced or disfigured finishes caused by work of this section.
3.12 DEMONSTRATION AND TRAINING
A. At a time and date agreed to by the Owner, instruct the Owner's representative on
the following procedures:
3.13 PROTECTION
1. Roof troubleshooting procedures.
2. Notification procedures for reporting leaks or other apparent roofing problems.
3. Roofing maintenance.
4. The Owner's obligations for maintaining the roofing warranty in effect and
force.
5. The Manufacturer's obligations for maintaining the roofing warranty in effect
and force.
A. Provide traffic ways, erect barriers, fences, guards, rails, enclosures, chutes and
the like to protect personnel, roofs and structures, vehicles and utilities.
B. Special permission must be obtained from the Manufacturer before any traffic will
be permitted over new roofing.
END OF SECTION
MAGH121038
07 52 16-14 MODIFIED BITUMINOUS MEMBRANE ROOFING