Specifications - Lord and Son Construction, Inc.

F. Pair and Set Match: Provide for doors hung in same opening.
G. Core: Particleboard core
H. Exposed Vertical Edges: Hardwood, of same or compatible species as face,
minimum thickness of 1/2 inch.
I. Construction: Five plies. Stiles and rails are bonded to core, then entire unit
abrasive planed before veneering.
2.4 ACCESSORIES
A. Glazing:
1. Refer to Division 8 Section "Glazing" for glass view panels in flush wood
doors. Fill glazing bead nail holes in factory finished doors.
B. Wood Beads for Light Openings in Wood Doors: Provide manufacturer's standard
flush wood beads unless otherwise indicated.
2.5 FABRICATION
1. Wood Species: Same species as door faces.
2. Profile: to be selected by Contracting Officer from manufacturer’s full line.
A. Factory fit doors to suit frame-opening sizes indicated. Comply with clearance
requirements of referenced quality standard for fitting unless otherwise indicated.
B. Factory machine doors for hardware that is not surface applied. Locate hardware
to comply with DHI-WDHS-3. Comply with final hardware schedules, door frame
Shop Drawings, BHMA-156.115-W, and hardware templates.
1. Coordinate with hardware mortises in metal frames to verify dimensions and
alignment before factory machining.
C. Openings: Factory cut and trim openings through doors.
2.6 FINISHES
1. Light Openings: Trim openings with moldings of material and profile selected.
2. Glazing: Comply with applicable requirements in Division 8 Section “Glazing."
3. Louvers: Factory install louvers in prepared openings.
A. General: Comply with referenced quality standard for factory finishing. Complete
fabrication, including fitting doors for openings and machining for hardware that is
not surface applied, before finishing.
11-008 08 14 16-4 FLUSH WOOD DOORS