Specifications - Lord and Son Construction, Inc.

APPENDIX A
QC CHECKLIST
This checklist is not all-inclusive of the requirements of this specification
and should not be interpreted as such.
This checklist is for (check one:)
Pre-Construction QC Checklist Submittal (Items 1-5)
|____|
Post-Construction QC Checklist Submittal (Items 1-12) |____|
Close-out QC Checklist Submittal (Items 1-19)
|____|
Initial each item in the space provided (|____|) verifying that requirement
has been met.
Items verified for Pre-Construction, Post-Construction and Closeout QC
Checklists Submittal:
1 Network bandwidth calculations have been performed, |____|
and the backbone type (Ethernet or TP/FT-10) has been
determined based on these calculations.
2 All DDC Hardware (nodes) are numbered on Control System |____|
Schematic Drawings.
3 Signal lines on Control System Schematic are labeled with |____|
the signal type.
4 Local Display Panel (LDP) Locations are shown on Control |____|
System Schematic drawings.
5 Points Schedule drawings have been sub-divided by device (DDC |____|
Hardware), including DDC Hardware node numbers.
Items verified for Post-Construction and Closeout QC Checklist Submittal:
6 All DDC Hardware is installed on a TP/FT-10 local control |____|
bus.
7 All Application Specific Controllers (ASCs) are BACnet |____|
certified.
8 Communication between DDC Hardware is only via CEA-709.1B |____|
using SNVTs. Other protocols and network variables other
than SNVTs have not been used.
9 Explicit messaging has not been used. |____|
10 System Scheduler functionality has been installed for all |____|
HVAC systems and default schedules have been configured at
each System Scheduler.
11 All sequences are performed as specified using DDC Hardware. |____|
12 Training schedule and course attendee list has been |____|
Section 23 09 23 Page 47