Operating Manual Vol 1 - ES Documentation

RF LevelSMIQ2.5.6 [RF ON / OFF]-KeyThe RF output signal is switched on and off again using the [RF ON / OFF] key. This does not influencethe current menu. When the output signal is switched off, the message "RF OFF" is displayed in theLEVEL indication of the header field. If RF OFF is displayed, the 50-Ω source resistance is maintained.IEC/IEEE-bus command:OUTP OFF2.5.7 Reset Overload ProtectionThe SMIQ is protected against overload by an external signal which is fed into the RF output. If anexternal signal is too high, the overload protection responds. This state is indicated by means of themessage "RF OFF" in the LEVEL indication in the header field and the message "OVERLOAD" in thestatus line. Reset the overload protection by pressing the [RF ON / OFF] key.IEC/IEEE-bus command :OUTP:PROT:CLE1125.5555.03 2.54E-8