Operating Manual Vol 1 - ES Documentation

SMIQEnhanced Functions For Digital Standard 3GPP W-CDMA (FDD)2.15.4.2 Test of Maximum Input Level with SMIQTo test the maximum input level of a mobile station (UE) (according to [1], 7.4) proceed as follows:1. In the DIGITAL-STD menu select menu item SET DEFAULT to set all parameters to defined values.2. Set sequence length to 13. (see section 2.15.4.3)3. Enter the DIGITAL STD-WCDMA/3GPP-ENHANCED CHANNELS menu.4. Set STATE to ON.5. Set CHANNEL CODING STATE to ON.6. Select CODING TYPE = MEASURE__12.2 and switch on both interleavers.7. Switch off EXTERNAL POWER CONTROL.8. Select a sequence length of 1022 (see section 2.15.4.3).9. Activate channel 11 (STATE to ON), all other channels are inactive.10. Set the following parameters for channel 11:CHAN CODE = 25 (not defined in [1], other code also possible)DATA DTCH = PN9DATA DCCH = PN15 (not defined in [1], other data also possible)11. Change to the DIGITAL STD-WCDMA/3GPP-OCNS CHANNELS menu.12. Set number of channels (NUMBER OF CHANNELS) to 60. (A value for [1] is not given but autilization of 50% for the code domain is recommended.)13. Set SYMBOL RATE to 30 ksps. (A value is not given in [1] but normal voice channels arerecommended.)14. Select CREST=MINIMUM.15. Set OCNS CHANNELS TOTAL POWER to –1 dB.16. Activate P-CCPCH (STATE=ON).17. Select –12 dB as P-CCPCH POWER.18. Set ENHANCED CHANNELS TOTAL POWER to –19 dB.19. Activate EXECUTE.20. Change to the DIGITAL STD-WCDMA/3GPP - BS1 menu.21. Set TFCI STATE = ON.22. Activate P-CPICH with –10 dB.23. Activate P-SCH and S-SCH with –15 dB each.24. Activate PICH with –15 dB. Select its channelization code so that no domain conflict occurs.Overview of all active channels in the OCNS measurement:Table 2-28OCNS channelsPhysical channel Power (log.) Power (lin.)DPCH (measurement) -19 dB 1.26 %CPICH -10 dB 10.0 %PCCPCH -12 dB 6.30 %SCH -12 dB 6.30 % -15 dB for P-SCH and -15 dBfor S-SCHPICH -15 dB 3.16 %OCNS -1 dB 79.3 % 60 channels, -18.8 dB each1125.5555.03 2.259E-9