Operating Manual Vol 1 - ES Documentation

SMIQDigital Standard PDC(SELECT SLOT...)ALL_DATABURST TYPESelection of burst type used to configure the selected slot.ALL DATA Burst type for testing with freely programmabledata contentsIEC/IEEE-bus command :SOUR:PDC:SLOT2:TYPE ADATSLOT LEVEL(UPLINK only)Selection of level for selected slot.OFF Maximum attenuationIEC/IEEE :SOUR:PDC:SLOT2:LEV OFFFULL The level corresponds to the value indicated onthe SMIQ LEVEL display.IEC/IEEE :SOUR:PDC:SLOT2:LEV FULLATTEN The level is reduced by the value set underSLOT ATTENUATION.IEC/IEEE :SOUR:PDC:SLOT2:LEV ATTBURST STATE(DOWNLINK only)Substitute for parameter SLOT LEVEL for downlink.ON The burst contents defined in the data fields aresent in the selected slot.IEC/IEEE-bus :SOUR:PDC:SLOT2:LEV FULLOFF Only 1s will be sent.IEC/IEEE-bus :SOUR:PDC:SLOT2:LEV OFFParameter SLOT LEVEL is omitted since the NADC basestation in downlink always sends with the same power ineach slot.R(UPLINK only)Display of data contents in the 6 bit data field "Ramp" inhexadecimal form..G(UPLINK only)Display of data contents in the 6 bit data field "Guard" inhexadecimal form.DATASelection of data source for DATA fields. These fields areregarded as a continuous field, ie a pseudo-randomsequence is fully continued from one DATA field to the next.The following data sources are available:PN.. PRBS data according to CCITT with periodsbetween 2 9 -1 and 2 23 -1.IEC/IEEE :SOUR:PDC:SLOT3:DATA PN15DLIST Data from a programmable data list.IEC/IEEE :SOUR:PDC:SLOT3:DATA DLISSERDATA Data from data input SER DATA.IEC/IEEE :SOUR:PDC:SLOT3:DATA SDATParameter SELECT DATA LIST... to EDIT DATA LIST...see menu selection BURST TYPE = TCH1125.5555.03 2.295E-9