Operating Manual Vol 1 - ES Documentation

SMIQDigital Standard PHS(SELECT SLOT) BURST TYPE... Opens a window for the selection of the burst type usedto configure the selected slot.TCH_FULL Traffic channel configuration (rate 32 kbit/s)IEEE-bus :SOUR:PHS:SLOT2:TYPE TCHFTCH_HALF Traffic channel configuration (rate 16 kbit/s)IEEE-bus :SOUR:PHS:SLOT2:TYPE TCHHVOXSYNCVOX configuration. In slots 4 to 8 (uplink)transmission is only in every fourth frame.IEEE-bus :SOUR:PHS:SLOT2:TYPE VOXSync burstIEEE-bus :SOUR:PHS:SLOT2:TYPE SYNCALL DATA Burst type for testing with freelyprogrammable data contentsIEEE-bus SOUR:PHS:SLOT2:TYPE ADATSLOT LEVELSET DEFAULTCS-ID SCRAMBLESTATESelection of level for selected slot.OFF Maximum attenuationIEEE bus :SOUR:PHS:SLOT2:LEV OFFFULLATTENThe level corresponds to the value indicatedon the SMIQ LEVEL display.IEEE bus :SOUR:PHS:SLOT2:LEV FULLThe level is reduced by the value set underSLOT ATTENUATION.IEEE bus :SOUR:PHS:SLOT2:LEV ATTResets the subsequent parameters to the factory-setvalues.IEC/IEEE-bus command :SOUR:PHS:SLOT8:PRESSwitch on/off of CS-ID scrambling function.IEC/IEEE-bus :SOUR:PHS:SLOT2:SCR:STAT ONCS-ID CODEENCRYPTIONSTATESECURITY KEYInput value in hexadecimal form for initializing thescramble generator.IEEE-bus :SOUR:PHS:SLOT2:SCR:CODE #H123Switch on/off of encryption scrambling function. Thisparameter is only available for TCH burst types.IEC/IEEE-bus :SOUR:PHS:SLOT2:ENCR:STAT ONInput value in hexadecimal form for initializing thescramble generator. This parameter is only available forTCHburst types.IEEE-bus :SOUR:PHS:SLOT2:ENCR:KEY #H12341125.5555.03 2.127E-9