Operating Manual Vol 1 - ES Documentation

List EditorSMIQSelect parametersModify parameters Mark the index associated to the parameter using the rotary knob or directlyenter the value of the index via the numeric keys. Press [SELECT] key.Parameter MEMORY is marked. If the second parameter DWELL is to bemarked, press the [SELECT] key again. Vary the value of the parameter selected using the rotary knob or enter thevalue directly using numeric keys.Note: The binary data of the digital modulations which cannot be variedare an exception. Further, all numeric keys except for "0" and "1" areineffective in these cases. Press the [ENTER] key or unit keys.The value is included in the data set. The menu cursor marks the value ofthe next column. In the last column, the menu cursor then marks the nextline of column MEMORY. Press the [RETURN] key.The menu cursor wraps back to the INDEX column. The EDIT mode isexited by repeatedly pressing the [RETURN] key (cf. Section 2.2.11.4).Block function FILLUsing function FILL, a parameter, e.g. MEMORY, is overwritten with constant or linearlyincreasing/decreasing values within a defined range. The input window is exited by pressing the[RETURN] key without a modification being carried out.If the filler range exceeds the end of the list, the list is automatically extended.The list entry, in the example for MEMORY, with index [AT +n] is calculated as follows from theinformation AT, RANGE, starting value (MEMORY) and WITH INCREMENT:MEMORY[AT+n] = starting value (MEMORY)+ n · increment | (0 ≤ n ≤ RANGE1)Selection:FUNCTION-FILLFREQ100. 000 000 0 MHz LEVEL- 30.0 dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDLF OUTPUTSWEEPLISTMEM SEQUTILITIESSELECT LIST...FUNCTION-INDEX - FREE 246 - LEN 1000010002000300040005000600070008FILL AT 10 RANGE 1PARAMETER MEMORY DWELLMEMORY 1WITH INCREMENT 0EXECUTEFig. 2-11Block function FILL: Input window1125.5555.03 2.36 E-8