Operating Manual Vol 1 - ES Documentation

SMIQFitting the OptionsConnectorThe clock and data signals output by the DUT must have TTL level and are connected to the BER (bit errorrate) input, a 9-contact SUB-D connector at the rear of the unit labelled BER. Pin assignment is as follows:SUB-D connector1,2,3,4,5 Ground Screen6 Bit clock input CLOCK7 Data input DATA8 Data enable input DAT ENAB9 Restart RESAdapter cableOrder No. 1110.3551.00Polarity of clock and data signals, the PRBS polynomial used and the integration time can be set bymanual or remote-control commands. The input signals are not terminated in the SMIQ but applied toICs of type 74LVT14 via a 220 Ω resistor. A cable is supplied with the option. Its contacts are assignedto BNC connectors as shown in the above table.1.3.12 Other Software OptionsSMIQB42 / SMIQB43 / SMIQB45 / SMIQB47 / SMIQB48 / SMIQB49 /SMIQB60 / SMIQK11 / SMIQK12You have acquired a software option to go with your Signal Generator SMIQ from Rohde & Schwarz.This option must be enabled by an installation keyword. Please affix the enclosed option label includingthe installation keyword to the rear panel of the SMIQ since it is required for service and repair. Forinstallation of software option SMIQB21 cf. section 1.3.11.Enclosed option label with a typical keyword:OPTION SMIQ-B43DIGITAL STANDARDW-CDMA1104.8032.02INSTALLATION KEY9 5 4 8 7 6MADE IN GERMANY