Operating Manual Vol 1 - ES Documentation

SMIQ Digital Standard W-CDMA (NTT DoCoMo/ARIB 0.0)Menu selection:DIGITAL STD - WCDMA - MULTICODE...FREQWCDMA100. 000 000 0 MHzLEVEL -30.0 dBmPEP - 14.9dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDLF OUTPUTSWEEPLISTMEM SEQUTILITIESPHSIS-95WCDMANADCPDCGSMDECTCHIP RATE STATE OFF ONLINK DIRECT MASTER CHANNEL 1MODULATIONTRIGGER MODEEXECUTE TRIG01234567TRIGGER....CLOCKMULTICODE OF CHANNELSXXXXXXXTOTAL POWERADJUST TOTALSAVE RECALLMULTICODE..Fig. 2-93Menu DIGITAL STD - WCDMA - MULTICODE..., equipped with options modulation coderSMIQB20, data generator SMIQB11 and SMIQB43MULTICODE... Opens a window for selecting multicode settings. The multicode mode cannotbe activated in the LINK DIRECTION/MULTIPLEX UP-IQ_MULT mode. In themulticode mode, the data fields Pilot and TPC have the same settings and arespread with the same spread codes of the MASTER CHANNEL for allselected code channels.STATESwitch on/off the multicode mode.IEC/IEEE-bus :SOUR:WCDM:MULT:STAT ONMASTER CHANNELMULTICODEOF CHANNELSSelection of the master channel. This channel definesspread code and contents for data fields Pilot and TPCin all multicode channels. The selection also causesthat parameters LONG CODE INIT, LONG CODEOFFSET, SYMBOL RATE and DATA OFFSET of theselected multicode channels are set to the samevalues as the master channel.IEC/IEEE-bus :SOUR:WCDM:MULT:MAST 1Selection of the channels for multicode transmission.The selected channels are marked with an X.IEC/IEEE-bus :SOUR:WCDM:MULT:CHAN #H1ESEQUENCE LENGTH[FRAMES]CHNODefines the length of the calculated chip sequence in number of frames.IEC/IEEE-bus command :SOUR:WCDM:SLEN 4Column title for the display of the number of the channel for which the settingsof the corresponding line are valid. The other columns can be selected with"=>" and "