Operating Manual Vol 1 - ES Documentation

SMIQDigital Standard GPSTRIGGER...EXT RETRIGGERINHIBITTRIGGER OUT 1/2Sets the number of chips by which a restart isdelayed after a trigger event. If the TRIGGER MODERETRIG was selected, every further trigger signalrestarts the GPS signal. This restart can be inhibitedfor the number of chips that have been entered.Example:Entry of 20460 chips (corresponds to a navigationdata bit) causes every further trigger signal to beignored for the duration of 20460 chips after the lasttrigger event.IEC/IEEE-bus command :SOUR:GPS:TRIG:INH20460Selects the signals for outputs TRIGOUT 1 andTRIGOUT 2 of the PARDATA connector.C/A_CODE Marker signal for every C/A-codesequence (1023 chips).IEC/IEEE-bus command::SOUR:GPS:TRIG:OUTP1 CODENAVBIT Marker signal for every navigation databit (20460 chips).IEC/IEEE-bus command::SOUR:GPS:TRIG:OUTP1 NBITNAVWORD Marker signal for every navigation dataword (30 bits).IEC/IEEE-bus command::SOUR:GPS:TRIG:OUTP1 NWORSUBFRAME Marker signal for every navigationsubframe (corresponds to 10words).IEC/IEEE-bus command::SOUR:GPS:TRIG:OUTP1 SFRFRAME Marker signal for every navigationframe (corresponds to 5subframes).IEC/IEEE-bus command::SOUR:GPS:TRIG:OUTP1 FRAMTRIGGER OUT 1/2 POL Selects the polarity of the signals at the TRIGOUT 1and TRIGOUT 2 outputs of the PARDATA connector.IEC/IEEE-bus command :SOUR:GPS:OUTP2:POLPOSTRIGGER OUT 1/2DELAYEnters the number of chips by which the selectedtrigger output signal is delayed.IEC/IEEE-bus command :SOUR:GPS:OUTP2:DEL01125.5555.03 2.337D-9