Operating Manual Vol 1 - ES Documentation

List EditorSMIQCREATE NEW LISTMSEQ2 100Generating a new list. The name of the list cannot be selected freely in thecase of manual control. A definite list name is automatically generated in thefollowing form:MSEQ, with ∈ {0..9}, e.g. MSEQ1 (with Memory Sequence)This applies correspondingly to the other operating modes. In the case oflevel correction mode, UCOR1 would be generated for example. If a list iscreated via IEC bus, an arbitrary list name can be given (cf. Section 3).Unrestricted access is also possible by means of the selection window.The list currently set is marked in the selection window by means of theselection mark, here MSEQ2. In addition to the list name, the length of the listis given, here 100 elements.2.2.12.2 Deletion of Lists - DELETE LISTDELETE LIST opens a selection window in which the list to be deleted can be selected. The lists arerepresented together with their name and their length (cf. Fig. 2-9). By pressing the [RETURN] key theselection window is exited without deleting a list.Delete list Mark desired list using the rotary knob. Press [SELECT] key.The prompt "enter [SELECT] to delete list/sequence?" is displayed Press [SELECT] key.The list is deleted. If the prompt is acknowledged with the [RETURN] key,however, the list is not deleted. The selection window is automaticallyclosed due to the acknowledgment of the prompt.Selection: DELETE LIST100. 000 000 0LEVEL- 30.0FREQ MHz dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDLF OUTPUTSWEEPLISTMEM SEQUTILITIESMODE OFF AUTO SINGLERESET SEQUENCECURRENT INDEXSELECT LIST...DELETE LIST...FUNCTIONMSEQ1 199MSEQ2 100MSEQ3 1MSEQ4 123Fig. 2-9DELETE-LIST selection window1125.5555.03 2.34E-8