Operating Manual Vol 1 - ES Documentation

SMIQArbitrary Waveform Generator ARB(SET SMIQ ACCORDINGTO WAVEFORM...)....IQ FILTER(VECTOR MOD)...IQ SWAP(VECTOR MOD)...PRBS (BERT)The parameter IQ FILTER (filter of LACP OptionSMIQB47) is set in the VECTOR MOD menu. If awaveform in WinIQSIM was compensated with thefrequency responses of this filter, it should beswitched on. A warning is output, if the waveform iscompensated, however, this compensation does notapply for an SMIQ of this serial number or if the optionis not fitted to the SMIQ.ON Parameter is setIEC/IEEE bus command:ARB:ASET:DM:IQF ONOFF Parameter is not setIEC/IEEE bus command:ARB:ASET:DM:IQF OFFThe IQ SWAP parameter in the VECTOR MODmenu is set. If a waveform has been generated inWinIQSIM for this mode, it should be switched on. Awarning is output, if the parameter is not set asindicated in the waveform.ON Parameter is setIEC/IEEE bus command:ARB:ASET:DM:IQSW ONOFF Parameter is not setIEC/IEEE bus command:ARB:ASET:DM:IQSW OFFThe type of PRBS in the BERT menu is set. If awaveform has been generated in WinIQSIM with thisPRBS, the latter should be selected with BERmeasurement. A warning is output, if the parameteris not set as indicated in the waveform.ON Parameter is setIEC/IEEE bus command:ARB:ASET:BERT:TYPE ONOFF Parameter is not setIEC/IEEE bus command:ARB:ASET:BERT:TYPE OFF...TRIGGER OUT MODEThe parameters TRIGGER OUT1 MODE andTRIGGER OUT2 MODE in the ARB MODTRIGGER... menu are set. Thus, the user can selectthe function of the SMIQ trigger outputs in WinIQSIM(see TRIGGER menu).ON Parameter is setIEC/IEEE bus command:ARB:ASET:TRIG:MODE ONOFF Parameter is not setIEC/IEEE bus command:ARB:ASET:TRIG:MODE OFF1125.5555.03 2.353 E-9