Operating Manual Vol 1 - ES Documentation

SMIQArbitrary Waveform Generator ARB(SELECT WAVEFORM...) SI COMPENSATION ON indicates that the SI compensation of WinIQSIMwas taken into account with calculation of thewaveform. Since the SMIQ, independent of thatcalculation, also takes into account the SIcompensation, it is disabled in WinIQSIM, if thewaveform is calculated particularly for the SMIQ. It ishowever counted back by the SMIQ, if it was takeninto account e.g., with calculation of a waveform forthe AMIQ.IEC/IEEE bus command:ARB:WAV:TAG? 'SI COMPENSATED'IF SIGNALSYSTEMCREATION DATECOMMENTCOPYRIGHTSMIQ SERIAL NUMBERON indicates that the waveform was converted intoan IF signal by WinIQSIM. This signal is notintended to be used as IQ vector. However, the usermay derive it from the I-channel output and apply asIF signal.IEC/IEEE bus command:ARB:WAV:TAG? 'IF_SIGNAL'Indicates the standard used to calculate thewaveform in WinIQSIM. The following standardshave been defined: Single Carrier, Multi Carrier,Multi Carrier Mixed Signal, 3GPP W-CDMA, IS-95,CDMA2000 and Import.IEC/IEEE bus command :ARB:WAV:TAG? 'SYSTEM'Displays the creation date of the waveform. Providesthe user with information and is added automaticallywith calculation in WinIQSIM.IEC/IEEE bus command :ARB:WAV:TAG? 'DATE'Is provided for information purposes and may beentered as comment text in WinIQSIM.IEC/IEEE bus command:ARB:WAV:TAG? 'COMMENT'Indicates whether the waveform was generatedusing the protected software WinIQSIM.IEC/IEEE bus command:ARB:WAV:TAG? 'COPYRIGHT'Is important, if the wave was generated in WinIQSIMwith IQ FILTER = ON. In this case, filter coefficientshave been used for compensation, which are bestonly for SMIQs with this serial number.1125.5555.03 2.351 E-9