Operating Manual Vol 1 - ES Documentation

SMIQUtilities2.29.2 Parameter of the RS232 Interface (SYSTEM-RS232)Submenu SYSTEM-RS232 offers access to the configuration of the RS-232 interface. The pinassignment of the interface corresponds to the pin assignment of a PC.Menu selection:UTILITIES - SYSTEM - RS232FREQ100. 000 000 0 MHz LEVEL-30.0 dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDLF OUTPUTSWEEPLISTMEM SEQUTILITIESSYSTEMREF OSCPHASEPROTECTCALIBDIAGTESTMOD KEYAUX I/OBEEPERINSTALLGPIBRS232SERDATASECURITYLANGUAGEDATA FORMAT8 BitsPARITYNOSTOP BIT 1BAUD RATE 9600 bpsHANDSHAKE OFF RTS/CTS XON/XOFFFig. 2-255Menu UTILITIES - SYSTEM - RS232DATA FORMATIndication of the number of data bits. This value cannot be changed.PARITYIndication of parity. This value cannot be changed.STOP BITIndication of the number of stop bits. This value cannot be changed.BAUD RATEHANDSHAKESelection of the baud rate.IEC/IEEE-bus command :SYST:COMM:SER:BAUD 9600Selection of the handshake.OFF No handshakeIEC/IEEE-bus command :SYST:COMM:SER:PACE NONE:SYST:COMM:SER:CONT:RTS ONRTS/CTS Hardware handshake using the interface lines RTS and CTS. Thismode always is to be preferred to XON/XOFF mode, if permitted bythe configuration of the host computer.IEC/IEEE-bus command :SYST:COMM:SER:CONT:RTS RFRXON/XOFF Software handshake using the ASCII codes 11h and 13h. This mode is not recommended for binary data and forbaud rates above 9600 baud.IEC/IEEE-bus command :SYST:COMM:SER:PACE XON1125.5555.03 2.411 E-9