Operating Manual Vol 1 - ES Documentation

SMIQLIST Mode2.27 LIST ModeA sequence of predefined frequency and level points is executed in the LIST mode, similar as in asweep. Differently from the sweep, however, a list with freely selectable pairs of values (frequency andlevel) can be generated. The specified range of the frequency comprises the entire adjustable frequencyrange of the instrument. The specified range of the level covers a 20-dB range. If the permissiblevariation range is exceeded, the level error increases.Caution:Table 2-33After the generation or change of a list in the LIST mode, function LEARN has to be startedto ensure that the new settings are transferred to the hardware (IEC-bus short command:LIST:LEAR.LIST mode; Example of a listIndex Frequency Level0001 100 MHz 0 dBm0002 575 MHz 13 dBm0003 235 MHz 7 dBm0100 333 MHz 5 dBm: : :Up to 10 lists can be created. The total amount of possible pairs of values including all lists maymaximally be 2000. I.e., a list may have 2000 entries at the most, or less if several lists have beencreated.Each list is identified by a separate name and selected via this name. A detailed description how toprocess the lists can be found in Section 2.2.11, List Editor.2.27.1 Operating Modes (MODE)The following LIST-operating modes are available:AUTOSINGLERun from the beginning to the end of the list with automatic restart at the beginning.If another mode was activated prior to the AUTO operating mode, continuation ismade from the current index.IEC/IEEE-bus commands: :SOUR:FREQ:MODE LIST:SOUR:LIST:MODE AUTO:TRIG:LIST:SOUR AUTOSingle run from the beginning to the end of the list. If SINGLE is selected, the run isnot yet started. Function EXECUTE SINGLE LIST to be executed, which can beused to start the run, is displayed below the MODE line.IEC/IEEE-bus commands: :SOUR:FREQ:MODE LIST:SOUR:LIST:MODE AUTO:TRIG:LIST:SOUR SING1125.5555.03 2.401 E-9