Operating Manual Vol 1 - ES Documentation

UtilitiesSMIQ2.29.8 Password Input With Functions Protected (PROTECT)The execution of calibrating and service functions is protected by a password. To unlock the lock-out,the correct password, a 6-digit number, has to be entered and then the [ENTER] key has to be pushed.After the instrument has been switched on, the lock-out is automatically activated.Password 1Password 2Password 3unlocks the lock-out for calibrations LEV PRESET and VCO SUM.unlocks the lock-out for calibration REF OSC.permits the input of the serial number and the value of the counter for POWER ON,operating hours and attenuator circuits.Menu UTILITIES-PROTECT offers access to the unlocking of protected functions.Menu selection:UTILITIES - PROTECTFREQ100. 000 000 0 MHz LEVEL - 30.0 dBmFREQUENCYLEVELANALOG MODVECTOR MODDIGITAL MODDIGITAL STDLF OUTPUTSWEEPLISTMEM SEQUTILITIESSYSTEMREF OSCPHASEPROTECTCALIBDIAGTESTMOD KEYAUX I/OBEEPERINSTALLLOCK LEVEL 1PASSWORD LEVEL 1LOCK LEVEL 2PASSWORD LEVEL 2LOCK LEVEL 3PASSWORD LEVEL 3OFF ONXXXXXXOFF ONXXXXXXOFF ONXXXXXXFig. 2-260Menu UTILITIES - PROTECT (preset setting)LOCK LEVEL XPASSWORD LEVEL XActivating/deactivating the lock-out.ON The lock-out is activated.OFF The cursor automatically wraps to the input of thepassword. After the password has been entered, thelock-out is deactivated.IEC/IEEE-bus command :SYST:PROT1 ONInput of the password; termination with [ENTER] key.IEC/IEEE-bus command :SYST:PROT1 OFF, 1234561125.5555.03 2.416E-9